Remove the steering arm from the tube and sand it with extra fine sandpaper.
Lubricating boat throttle cable.
Find a short piece of hose that fits over the cable end.
Cables may be sprayed lubricated every so often however grease is not recommended as it has a tendency to retain moisture.
On the vast majority of fuel injected modern bikes the throttle cables have open ends just like the clutch cable.
With a few twists of a screwdriver and a few taps of a hammer you get a lubricated throttle control cable and the grand tour of your outboard s throttle control system.
For cable lifts use a marine grade grease to lubricate bearings and pulleys.
Lubricating an outboard motor s throttle cable appears to be a straightforward proposition.
Do you have a p.
This video will show you the fastest way to lube your brake throttle clutch or any other cable you may have.
Directions for a throttle and shift cable oiler you need a foot and a half of 3 8 id reinforced plastic hose from lowes a tire valve three hose clamps a tire pump or small 12 volt air compressor with a gauge and some mmo marvel mystery oil.
To lubricate the entire cable you must remove it from the boat.
Control cables that are really difficult to remove and install make a strong case for replacement rather than the band aid repair of lubrication but if your cables are accessible lubricating can be an expenditure deferring alternative.
What that description doesn t address is the adventure you face as you gain access to the throttle cable ends to which you must apply the lubricant.
You add lubricant to the cable.
If your bike is carburated it is typical for the cable to end up inside the carburetor housing.
Control cables that are really difficult to remove and install make a strong case for replacement rather than the band aid repair of lubrication but if your cables are accessible lubricating can be an expenditure deferring alternative.
If that s the case you ll have to remove the cable end from it s housing before lubing to avoid pooling the carb with dirty cable lube.
If the cable route is ok and your sure its just an old cable you could lube it by injecting a penetrating oil like crc and or liquid wrench.
Shave the tire valve down and clamp it in one end of the hose.
Motors and their parts should be oiled using an anti corrosion lubricant at least twice a year depending on use.
This task should be done every six months or so.
Don t have a cable lube tool.
Step 2 clean any hardened marine grease from the inside of the tube by spraying the inside of the tube with a penetrating lubricant.
This can be dead simple or an all day job depending on how the cables are installed and routed on your boat.
To lubricate the entire cable you must remove it from the boat.
