How To Tension Garage Door Torsion Springs

You may also notice your garage door falling to the floor much.

How to tension garage door torsion springs.

If the garage door isn t opening or closing properly then check the tension on the torsion springs for needed adjustments. A problem with the spring tension could cause the door to open or close unevenly improperly or at the wrong speed and adjusting the springs will likely solve the problem. This video applies t. A garage door that is bent at the top upper section can also be a glaring and costly sign of a broken torsion spring.

The torsion spring helps the garage door open and close easily. If there are multiple springs on your garage door we strongly recommend replacing both torsion springs. When the door is closed and at rest the torsion spring stores enormous amounts of energy and when you want the door to open the spring helps by uncoiling and releasing that energy. Torsion springs extension springs and other garage door hardware can cause serious injury or death if not handled and installed properly.

Be sure to have all your tools inside before closing the door unless you have an alternate access door to the garage. Professional installation is recommended. The springs are located at the top inside part of the garage door. If you re concerned about tackling this project on your own consider hiring out the job to a professional.

Professional series springs not from china torsion spring s for torsion systems set above the garage door. Torsion springs store energy by coiling tightly as the door as the door closes. Do not attempt to install springs or hardware yourself unless you have the proper tools reasonable mechanical aptitude and experience and upper arm strength. Torsion springs must be adjusted with the door in the down position.

If your garage door isn t operating properly the torsion springs are likely to blame. Sectional doors and hinged doors are adjusted using a basic procedure for. We we offer a vast selection of wire and spring sizes and both left and right wind torsion. Otherwise replace both the left and right springs at the same time to save yourself from having to do the job twice.

Torsion springs sit against the wall over the garage door. Winding bars are 18 in length and are also advised when winding and un winding springs. There are two torsion springs at each side of the garage door. Adjustment to torsion springs can be dangerous because they must be adjusted with the door down and the spring under tension.