How To Attach Vinyl Siding To Concrete Wall

After the furring strips have been installed vertically on the wall you may install any siding you wish.

How to attach vinyl siding to concrete wall.

Easiest and only way to install vinyl siding over the cinder block wall is to nail on something called furring strips. Use nails that are no longer than the furring strips are thick so that they don t penetrate the concrete behind the strips which would cause the nails to bend and damage the siding. Furring strips are basically 1x3 or 1x4 strip of wood that are vertically nailed every 16 inches on center using masonry or concrete nails. Install the boards horizontally placing them flat against the.

At the top of a furring strip drill a hole. There are hundreds of colors to choose from when you decide on installing vinyl siding. Measure the width of one block wall and cut treated two by fours to match. You do not need tyvek if you are going over concrete and using treated furring strips.

Place the strip so its center is lined up with the vertical line. Remove any siding or exterior finish that isn t compatible with vinyl siding and make sure the walls are sheathed with a substrate to receive the siding. You re on the right track. How to install siding on concrete block house.

Yes i would put insulation board between the furring to add some support to the vinyl. Install a strip of insect netting along the bottom edge of the concrete wall by nailing the. The concrete foundation is nearly flush with the first floor siding meaning that using furring strips would cause the new siding to stick out. Line up the hole in the strip with the top hole you drilled in the wall.

The vinyl siding that around the concrete portion that i want to cover up is attached to an osb board that s attached to the framing of the house. As a result the osb protrudes about a half inch farther out than the concrete. No you do not want the vinyl to come in contact with the ground the siding could deteriorate. The contractor proposed using tapcons to attach the siding directly to the foundation which would allow the siding to line up with the first floor.

The number of strips you need. In effect i would need to add a bit of spacing between the concrete and the siding. You want to nails these in to the block joint not the block itself. Vinyl siding colors are not restricted to the limited five or ten pastel colors that were the choice for so many years.

Nail 1 1 2 inch thick wooden furring strips to the concrete wall at 4 foot intervals using concrete nails. Vinyl siding is a great material to dress up a concrete block structure. Insert a sleeve anchor into this hole and tighten the anchor enough to hold the furring strip in place.