Once your wood filler is mixed use it quickly.
How to apply wood filler to log siding.
Apply the filler to the craft sticks using another craft stick or a putty knife.
Apply the wood filler using a putty knife.
Attach the log sidings to your studs using the 3 inch lag screws.
It s important to get all.
Cut the foundation log sidings to fit between the corner logs.
6 then using a putty knife shaped piece of wood or a finger tool the bead to further force the sealant into intimate log contact.
Start at one end and gradually work your way to the other end.
Overfill slightly to allow for the fact that the filler.
If you don t have a tube use a putty knife to apply it.
Squeeze the filler into the hole.
Make sure you install the foundation log along the bottom of the wall.
It is best to fill in two or three steps rather than try to fill a deep hole in one pass.
Scrape all loose paint from around the area to be repaired using a paint scraper or putty knife.
Mix it first according to the instructions on the container.
Dig out all the rot from inside the crack or hole with an awl or a flat head screwdriver.
The filler should be level and even with the surface of the wood.
After they dry they can be sanded molded painted or stained to match your existing log siding.
The craft sticks will act as a support for the wood filler.
Apply epoxy wood filler with a putty knife as an alternative to using caulk.
While tooling scrape the excess sealant from the sharp edges of the check and remove any material that may have smeared over the surfaces of the adjoining logs with a wet rag or sponge.
Fill the crack completely then scrape the excess from the.
Start at the edge of the damaged area pressing the wood filler into the depression.
Correct way to apply wood filler to exterior siding 1.
Cut and install the foundation log.
The best substances for plugging holes and filling cracks with this old house general contractor tom silva.
These epoxy fillers set up fast so only mix what you can use within 15 minutes.
Subscribe to this old house.
Use the tube to squeeze the filler into the area making sure to fill in the deepest area by pressing the end down into it.