Step flashing on roof peak.
How should i flash where the roof meets the siding.
Roof shingle over step flashing.
It is at the back of the porch roof where the roof meets the house siding.
Flashing where wall meets roof.
Today the flashing is on top of the siding.
And slip i w and step flashing under.
That is fine but it must still look like the flashing is behind the siding.
Kickout flashing installs just like standard step flashing except that half of the kickout flashing hangs over the edge of the roof.
Flashing is a strip of metal usually aluminum about 8 inches long and bent at 90.
Install the kickout flashing.
The vertical flange of the flashing is to extend up behind the adjoining siding.
Step flashing is used where a roof meets a wall to cover the junction of those elements preventing leaks.
If it s vinyl we just pop the j with a flat bar.
The solution to rotting sidewalls is a small piece of bent metal called a kickout flashing at roofing suppliers which simply directs all that water away from the wall.
If it s wood usually cedar shakes around here i figure in the material and labor to pull that off and properly flash it.
Bend the corner flashing tightly around the corner.
The roof deck flange of step flashings are to be fastened to the surface of each shingle in a position whereby the next course of shingles will cover up hide the flashing from view.
This flashing should not be seen for it disrupts the architectural balance of the house.
